|
Fastening instructions for Combi and Combi+ profiles
| Step 1 | | | 
| Screw or dowel the basic profile (= plug installation). In case of floor heating, fix the profile by using the Parkettfreund polyurethane glue. |
| Step 2 | | | 
| Adapt parquet, laminate, cork or veneercovering
(pay attention to EXPANSION JOINT)! |
| Step 3 | | | 
| Only for 6.5 - 8.5 mm thick floor coverings observe, that the long side of the cover profile is in the exact position to the shiftnute of the basic profile! |
| Step 4 | | | 
| Screw cover profile (upper part) on basic profile. |
| Step 5 | | | 
| Only for Combi profiles: Adapt differences in level by well controlled hammer blows (impact block). FASTEN ALL SCREWS AGAIN AFTERWARDS! |
| | 
| Only for version with decoration foil or real wood veneer:
Remove protective strip and stick on wood decoration foil or the real wood veneer at room temperature (never at temperatures below zero). Use feeder guide edge!
|
|
