HomeAbout usProductsReferencesNewsContact
Fastening instructions for Premium-Click profiles
Advantages of the new Premium-Click profiles
  • profile system for laminate (6 - 10 mm) or for parquet (10 - 16 mm)
  • the basic profile can be glued or screwed
  • simple, easy and timesaving installation
  • the screws are not visible
  • well-designed TOP-profile
  • elegant colours and decorations
  • The profiles are packed in a transparent film and with a label. This protects the profile. At the same time the packaging, reduced to a minimum, maintains the high-quality appearance of the profile. The plastic tab for single packaging with an integrated   box for the screws ensures the optimal hold in the shelves


Premium-Click
connecting profile		  
Premium-Click
border profile		  
Premium-Click
adapting profile

Step 1
 


Screw or dowel the basic profile (=plug installation). Please observe a distance of 2 - 2.5 mm to the wall when using the border profile. In case of an underfloor heating the basic profile can be glued to the concrete with the Parkettfreund polyurethane glue.

Step 2
 


Adapt the floor. Observe a distance of the expansion joint according to the instructions of the producer of the floor covering.

Step 3
 


Before installing the TOP-profile please remove the transparent protective strip from the decoration foil. Afterwards just click the TOP-profile by hand onto the basic profile...

Step 4
 


... and adjust with well controlled hammer blows (impact block).

Dismanteling
 


Drill the TOP-profile as close as possible to the frame with a diameter of 3 mm. Then use a 4 mm screw with a length of approximately 50 mm. By the screw touching the basic profile the TOP-profile is removed from the basic profile.

top
Search